The Challenges to Swim Spa Covers

Swim Spas represent special challenges when it comes to covering them.
We can all agree that the swim spa has to be covered when not in use for all the same factors a hot tub needs a cover. The obstacle is that because of the length of the swim spa and the height of the sides, getting rid of and replacing the cover can be a lot more difficult.
Getting a new swim spa is an amazing occasion in life. You’re eagerly anticipating the workout you’ll get from using it. Perhaps you’re a little relieved to have finally selected from the various models you took a look at. At any rate, you most likely weren’t thinking much about the cover you would use.
Generally, the cover that gets back with your new purchase will be a 4 section rigid foam filled cover that will divide in the center and go off both ends.
No big deal.
Till it begins to get heavy.
Which it constantly does.
Every stiff foam filled Swim Spa Cover ever made winds up the same way and it is not the fault of the user. It’s a style flaw. Built in obsolescence due to the fact that as quickly as it is put in use over the warm water in your swim spa it is inevitable.
It’s not from rain, so having a taper won’t make any difference. In fact you might have it under a roof and the cover will still get heavy.
The factor is the steam from the water. The molecules of steam are very little as they increase from the water surface area. They make their method into the little fractures and crevices in the foam. Then as the steam cools it forms back into a liquid and ends up being caught in the cover.
It occurs slowly and on a Swim Spa Cover which is made from specific areas, at differing speeds. So eventually you’ll observe one or two of the sections are really getting heavy. The bar lifters on the ends of the swim spa aren’t much aid due to the fact that you still need to raise that heavy cover back up onto the spa which is a lot higher than a routine spa.
This is why SpaCap.com created a different style for their Swim Spa Covers
Instead of using several foam panels to construct Swim Spa Covers that will eventually end up in some garbage dump, they developed one that uses air chambers that do not suck up moisture.
In fact SpaCap.com Swim Spa Covers are light-weight, insulate better, won’t blow away in a wind storm or be harmed by snow or hail.
Covered with Sunbrella Marine fabric, these covers will not fade, or fall apart at the joints either. So if you own a swim spa, and you intend to keep using it daily, SpaCap.com has the Swim Spa Cover for it.
If you’re not all set to buy today, bookmark this site so you can find it once again when you’re all set!

Leave a Reply

Your email address will not be published. Required fields are marked *